You’re offline. This is a read only version of the page.
Alignment problems between the pendulum roller and the lower welding roller
Basic settings and parameters CM21
Canbody transport motor on CM16/S doesn’t move correctly
The wire moves back and forth and finally the wire breaks
There's not enough power, the cans can't be welded properly
The (temperature heatsink) is too low (T water)(Low Temp.)
Tool sensor temperature jumps up. Machine shuts off. Error Temperature difference too big
Under square can bodies are jamming before / in the tooling
Unwelded sections at the beginning and at the end!
The C-bank is not reaching the necessary voltage within the pre-charge time
The display shows "Max … @ dot …" always 0.
Change of the processor board
Display shows Phase T error (Old version Pacemaker)