Under square can bodies jamming

Under square can bodies are jamming before / in the tooling

Remedy:

1. Check the blank cutting tolerances and blank squareness. See attached PDF
    
2. Adjust the rollformer (roller shaft clearance and spring pressure) according to the manual.
    
3. Control if there is a high difference in the tin plate hardness, by rollforming 10 bodies without welding.
   • Put them on the floor in line and compare the difference in the rollforming overlap.
      
4. Check if the de-stacking process is going well.
   • Make sure the tin plate is guided tight, and the separating air is positioned well.
      
5. Control the timing of the tin plate transport in between two transport fingers.
    
6. Make sure that the guidance channel is properly adjusted.
   • The intersection to the pre-calibration of the calibration crown is most important.
      
7. Check the position of each (inside and outside!) transport finger compared to rollformed can body.
    
8. Check the offset of each finger pair itself.
   • Move the can body slowly forward (X1 and X6 by slow mode function) and observe eventual shaking of the can body until the welding point.
      
9. If a third finger exists:
   • The third finger must be 0.5 mm behind the upper main pusher fingers!
      
10. Reset the calibration crown completely.
     
11. Make sure that each pre-calibration roller is turning easily!
    • If needed lubricate their shafts slightly and clean the roller afterwards. Make sure that these rollers are as close as possible to each other!
       
12. Measure the speed of the flat belt in the calibration crown:
    • The speed must be absolutely identical with the copper wire speed!
       
13. Measure the over travel:
    • Short can heights shall have 1 mm over travel.
       
14. The center of the diabolo roller (equal to the center of calibration crown) shall be 1–2 mm before the welding center.