Alignment problems between the pendulum roller and the lower welding roller
- The roller head offset is fixed on the X-Series machines and cannot be adjusted.
- If you need to adjust this setting for any reason, first make sure what the result of the offset is.
- To adjust this offset, you have to loosen the two M8 screws of the holder from the welding pressure cylinder.
- Additionally you have to loosen four M6 screws (1- two are shown), that hold the plate (2). Now you can shift the position of the pendulum roller slightly in the various hole.
NOTE:
Do not make any adjustments on this shaft!
- Check the offset value again and securely tighten all screws.
