You’re offline. This is a read only version of the page.
One of the safety relays of an the emergency stop or protective door circuit was not restarted after operation.
How to formate (delete) the RAM disc on the SWM-1 CPU-board (141) without PC.
How to generate a spy.txt file for CAN bus data analysis
UNICONTROL system is not capable of automatic PULSAR download
Procedure after an unforeseen power failure that has destroyed the D:\ partition.
Welding profile is inconsistent.
Pulsar software update
The welding current profile is too complex.
More than 10 can bodies arrive at the ejector, which do not have any quality information or do not have quality information for all channels.
Too many missing can bodies at eject station. Irregular can body flow.
There are more than 30 can bodies between eject sensor (A014 Input 1) and eject station. The buffer section overflows.
The “Event and status log” page shows whether the monitor setup was successful.
The sensor of the eject station does not detect any gap over more than two and a half can-body lengths.
A sheet passing through the double-sheet sensor is not detected at the end of the sheet conveyor.
Double sheet measurement in the rollformer