How to generate a spy.txt file for CAN bus data analysis
Preconditions
Must be a Unicontrol machine or monitor with XPe operating system.
The PC must be powered on without an error.
Machine must be in setup mode (set key on control panel to manual)
Note
If you insert the flash disk after you have powered on the machine, you can plug in and plug out the flash disk at any time.
If the machine was powered on with an inserted flash disk, you must switch off the machine before unplugging the flash disk.
Description
Insert the flash disk into PC (control panel)
Choice “service” page
Press →
→
→
( →
for older SW Versions you have to press the spy button twice)
Set “Spy dump since” to 15 min. The fault (or your can data) must have occurred not longer
then 15 minutes ago.
If you are not sure about the time set the “Spy dump since” to 60 min. Then press →
Press
→
→ Press
(For older SW Versionsyou have to use the backup button insteade of the save spy button
to copy the spy to the flash disk)
→ Go back to production page
You will find the generated spy.txt file on your flash disk (Every new spy will overwrite the old one).
The file is located on the flash disk drive:\Data
Send the flash disk\data directory as zip file with your comments to Soudronic's Customer Service.