You’re offline. This is a read only version of the page.
Production data have not been stored in the monitor This message can come from the energy, heat, powder or pulsar channel. The respective channel is indica
The GCC loads invalid limit values during calibration.
As the monitor is switched on, no valid setup data are available.
Energy, heat, powder monitor: No limit values are stored in the monitor.
The welding machine production is no longer the same as it was during calibration.
After the Feeder ON signal, the first two machine cycles are not stable.
One or more measuring signals are not correctly present.
The analog card does not respond.
ONLY WITH DCD: One or more can bodies pass the can-body sensor but no speed signal (A032 input 1, A032 input 4) is present.
Line stop Outside seam protection system (PRC; brushes ANL, spray LAS, OSS or double OSS coating) triggered a line stop at the welding machine.
Line stop Inside seam protection system (LNS, LAS spray lacquering or powder application) triggered a line stop at the welding machine.
Delay until a oven switches over to ‘small flame’.
When switching on the powder unit, this message indicates that the CPF/FDC silo is not yet full (ready).
Fine tune the double sheet detector with the: "Double sheet: correction" value on the parameter page
How to react and get out of a fatal error