You’re offline. This is a read only version of the page.
Powder falling off, while the can body is moving through PowerCURE™
Are there any requirements for the water quality of the cooling system?
Bubbles in the outside wet lacquer after curing
The (temperature heatsink) is too low (T water)(Low Temp.)
What's an overvoltage suppressor? Is this a built in standard and how does it look like?
How to change a processor board?
How can I check if the magnet valve is blocked?
How to check whether the powder is properly cured
What to do if the analog output(s) are defective?
Diodes between IGBT’s are damaged
Do you have an error list from Pacemaker HF High Frequency Generator?
How to check, if I have enough cooling energy for PowerCURE?
Sparking on the induction coil! Error: "Output overcurrent", "CH-driver fault" or "Frequency abnormal"
The PowerCURE™ is running and heating, but the display shows no current or power
The water flow of the coil is too low