You’re offline. This is a read only version of the page.
The emergency stop button on the machine has been pressed.
The suction bar overload clutch is disengaged.
Lubrication: oil level
The emergency stop button on one of the manual controls in the line control has been pressed.
The regulator control (contamination) has tripped.
Rollformer with double sheet deflector
Energy: During calibration the contamination must not respond before or on the first can body.
Perform SCANDISK - A corrupt disk structure can be a possible cause of problems that prevent the GCC from starting.
Check screws from Pulsar to welding transformer.
The GCC stops with a fault message: "required hardware missing or faulty"
Welding current or frequency too high
The protective door to the wire loop is open.
The signals from a sensor do not correspond to what the control expects.
Unicontrol node destack A004 digital input 10
Unicontrol node Destack A004 digital input 7