You’re offline. This is a read only version of the page.
An internal error of the ACOPOSmulti device has occurred.
If the axis manager does not find a required axis on the power link bus (bus which interconnects the axes), an error is indicated.
An internal monitoring of the servo amplifier has exceeded a limit, triggered an error and shut down the amplifier to protect the device from overload.
An error regarding the resolver of the motor has occurred.
A hardware release signal for the ACOPOSmulti is missing. The servo amplifier cannot be switched on.
An electrical error has occurred in connection with the motor, such as short circuit or interruption.
Welding section identification was unsuccessful because the measured values were too different.
Welding section identification was unsuccessful because all three measured values were the same. There is probably an error.
Welding section identification was unsuccessful because the required identification current was not reached.
The identification of the welding section was not successful because it was interrupted.
Welding section identification was unsuccessful because there was no current flow.
The software version on the Pulsar is not up-to-date.
A monitoring in ACOPOS has triggered an error and switched off the servo amplifier to protect the motor.
The temperature of the servo amplifier (or the power supply) is measured with temperature sensors.
The wire traction is monitored. If the wire traction is not constant or exceeds/falls below the warning limits, the machine is stopped.