You’re offline. This is a read only version of the page.
The maximum number of can bodies in the ejection container at the end of the oven has been reached. The container is full.
The temperature of the oven transformer is too high. If the temperature is higher than 80° C, an error message is issued.
Can upender "Upender DCU" downstream line is not ready. The downstream line or can-body conveyor is not ready (input A052:Input 6 is low).
The OHC conveyor is open.
The motor is too hot.
The servo amplifier is too hot.
Welding profile is inconsistent
All digital outputs which come from plug X9 need a nominal supply voltage of 24V.
The pulsar has detected contamination.
An error has occurred in relation to the motor brake. The brake control occurs autonomously from ACOPOS with the brake output.
The clutch of a chain conveyor is disengaged.
The clutch did not engage.
The clutch did not disengage.
A problem occurred with the Powerlink communication. This concerns the internal drive system communication and NOT the CAN or Profibus.
Before the servo amplifier is switched on, monitoring has checked the DC bus (link) and has determined that the voltage is too low.