You’re offline. This is a read only version of the page.
Line control with OPC communication. The downstream control unit demands production interruption.
LTC: the lacquer temperature in the OSS outside seam lacquering unit has exceeded the maximum.
Wire threading STW
The oven pyrometer can be used as temperature monitor at the end of the oven.
The oven pyrometer can be used as temperature monitor at the end of the oven.
The oven pyrometer can be used as temperature monitor at the end of the oven.
Line interface Only possible in automatic mode. The upstream system is triggering an Off error command.
OSS outside seam lacquering with LTC The temperature controller PID status is at the upper or lower limit.
Inside lacquering monitor: the lacquer flow pulses at input A015:In5 are too short.
Outside lacquering monitor: the lacquer flow pulses at input A015:In8 or A046:In8 are too short. The pulses are shorter than the specified minimum value.
Safety controller: An error in the safety circuit indicates a problem with one of the safety components
With the welding machine, you can move to the zero points with the servodrives.
Lifting table The top-most position of the sheet stack is regulated automatically.
SWM2 standalone monitor
More than X defective can bodies in the last Y can bodies from the current series