You’re offline. This is a read only version of the page.
Each change of the can-body height will be registered in the status log. This message is just informal.
Fuse rating of external link connections is defective.
The direct voltage over the link from the zero point to +VDC and -VDC deviates at least 100 V.
When loading the link via the softstart, the DC link voltage is measured after K1 is switched on.
This error is triggered as soon as the measured DClink voltage of the PULSAR exceeds the peak input voltage by 100V or exceeds the absolute value of 800VDC
The DC link voltage remains in operation under a certain value compared to the power input. Two events result in this error.
All digital optocoupler outputs are short-circuit-proof. If a current of approx. 100 mA is reached then the output switches off and the error is displayed.
One of the connected IGBT drive cards could not be addressed via I2C.
One of the connected IGBT drive cards could not be addressed via I2C.
One of the connected IGBT drive cards could not be addressed via I2C.
One of the connected IGBT drive cards could not be addressed via I2C.
The welding current gap is too small in PULSAR xx1 devices (EWave).
Access violation when reading a parameter by the superordinated control unit
Access violation when writing a parameter by the superordinated control unit
The I2C module is not addressable due to a defective controller card.