You’re offline. This is a read only version of the page.
The logic for the ejection node has not been started internally. The monitor icon remains red and does not change to green.
A can-body jam has occurred in the EAC, DCS, can upender or the line interface.
Rear protective door is open.
Check welding transformer, Pulsar.
Rear protective door is open.
Lifting table The top-most position of the sheet stack is regulated automatically.
The entire line stops as soon as an emergency stop button of the line is pressed.
The emergency stop from the external control unit is active.
The DISCON pump can be switched off when cooling circuit 2 is disabled.
Line control has triggered a line stop at the welding machine.
A cooling circuit has fallen below the minimum flow rate. The measured values are shown on the GCC "Cooling water" page.
The protective door of the manual magazine loading is open.
Line control with OPC communication. The downstream control unit demands immediate production stop.
Line control with OPC communication. Communication via OPC interface has been interrupted.
Line control with OPC communication. Communication via OPC interface has been interrupted.