Check welding transformer, Pulsar.
Description
Check welding transformer, Pulsar.
Remedy
- Check screws from Pulsar to welding transformer.
- Check transformation ratio of welding transformer in control unit.
- Carry out system identification.
- Contamination also in short circuit?
- Yes
Check the roller head - No
Continue with next step
5. Switch welding monitor off for troubleshooting
6. Check contamination settings. Too sensitive?
Execute Monitor Setup on the Unicontrol Monitor Setup and check level of sensibility
7. Q1 values over 10% are not acceptable!
8. Check mechanical settings, check welding pressure, does the spring run perfectly?
9. Check sheet quality.
10. Problem solved?
- Yes
Check during production. - No
Not a Pulsar problem!