You’re offline. This is a read only version of the page.
Line control has triggered a line stop at the welding machine.
The bodyformer operator would like to run the line until it is empty. The welding machine is stopped and the line is run until it is empty.
The SCU seam cooling unit for the oven is not ready.
An error has occurred in inside seam lacquering.
The regulator control (contamination) has tripped.
Heat channel: pyrometer The pyrometer (measuring head amplifier) in the heat channel of the monitor is not ready.
The can-body guide could not be closed.
Open/close the rollformer.
Open/close the rollformer.
Line interface The machine was stopped by an external Machine Stop command.
Line interface The machine was stopped by a Machine Stop command.
An emergency stop was triggered by the enabling switch.
The light curtain is interrupted. The light curtain is monitored in setup mode 1 only.
The designated sensor is dirty. A wrong sensor signal is detected in the machine's steady-state condition.
No can bodies were detected by the inside seam lacquering system after production started.