You’re offline. This is a read only version of the page.
No can bodies were detected by the outside seam lacquering system after production started.
External cooler The temperature monitor of the external cooler has tripped. This is just a warning. Production can continue.
External cooler The temperature monitor of the external cooler has tripped.
The inlet pressure of the compressed air supply is too high.
Lacquer monitor for internal or external spraying The lacquer monitor is ON, but the lacquer application is OFF.
Wire run-in The system monitors for correct wire unwinding and detects knots.
Wire magazine Wire supply is used up.
The hardware node is checked at startup and, if appropriate, an error message is displayed.
Powder Soucoat equipment with pressure control
CANopen Bus The CANopen bus is an independent CAN bus which is connected to the Unicontrol via a gateway.
The drive system starts. This message is automatically acknowledged as soon as the drive system is ready.
Rounding machine More than three sheets in a row have been detected as double sheets.
When switching on the powder unit, this message indicates that the CPF/FDC silo is not yet full (ready).
A can-body jam has occurred in the EAC, DCS, can upender or the line interface.
Energy monitor During the series start-up of the monitor, the voltage is measured in short-circuit current.