You’re offline. This is a read only version of the page.
The handwheel of the main drive is coupled.
The position pin of the conveyor 3 synchronization shaft is not in parking position.
The feeder magazine is open.
The scoring station is open.
The suction bar overload clutch is disengaged.
The "Air pressure too low [Air] supply tool" monitoring has responded in production or setup.
STW machine - Tongue cutter The tongue was not ejected.
STW machine - tongue welding station More than three tongues were missing in a row at the tongue sealing station.
Sorter - run-out (Transout) Each tube receives a quality message (good - bad) during automatic production.
During calibration of the monitor, detection of the can-body at the ejector must be stable.
Feeder A line stop becomes active on the welding machine when the sheet stack has not reached the necessary level.
BWM machines only The chain brake of Conveyor 1 is not released.
SOUTUBE plate roller monitoring The plate rollers in the welding station are monitored for a minimum speed ($SoutubePlateRollsMinSpeed).
The rounding speed has changed. It is determined by the sheet length in the feeder.
Pulsar could not be switched on.