You’re offline. This is a read only version of the page.
The Adaptive Rounding System ARS could not determine the impact point on the measuring plate.
Burner element is not heating up. The required temperature cannot be reached even at maximum setpoint value.
The measuring plate of the adaptive rounding system ARS has a short-circuit connected to ground.
The number of measured values per tank, can-body, or drum is greater than 2048 values.
Protective doors - safety device
Protective door above the handwheel on the left side of the machine is open. The can-body guide channel is pushed through this protective door.
Powder monitor temperature calibration. The specified setpoint value could not be reached.
Souvis system is in fault condition. The Souvis computer reports that the Souvis is not ready or there is a general Souvis error.
CAN bus communication Unicontrol to Souvis Every report over the CAN bus from Unicontrol to the Souvis must be confirmed.
A circuit breaker or motor protecting switch has tripped.
Interface tube conveyor - press As soon as the tube conveyor to Soutube is ready to take a tube, the press requests a tube.
Souvis reason for ejection of an NOK tube This message is informational and not an error. Reason for ejection is shown on the monitor page.
SOUVIS reason for a fault with an NOK tube This message is informational and not an error.
Wire compensator Soucan 100/200 The welding rollers must be open when correcting the wire length between the upper and lower welding rollers.
Grease lubrication is monitored in automatic mode and during setup.