You’re offline. This is a read only version of the page.
Synchronization machine cycle for feeder messages
Feeder protective door is open.
The clutch of the rollformer is disengaged.
This message appear when parameter $MonitorMachineOffAfterTwinCan TRUE is set. A twinned can body was detected at the ejector.
Feeder with DMC linear or rotating drive The vacuum was reset too late. The operator can extend the vacuum off in the GCC.
The first can body reaches the can-body sensor of the ejector more than one can-body length earlier or later than was measured in the setup.
The pulsar has detected contamination.
Contamination was detected during setup or overlap measurement. The desired function could not be correctly performed.
Oven system without monitor eject system
The system downstream from the line has stopped. The input transport rotary plate is stopped.
Welding machine conveyor 1
Automatic adjustment of the feeder width
Automatic feed of the sheet stacks in the feeder
Lacquer monitor with LNS or LAS
Lacquer monitor with LNS or LAS