783.x Line: Turner outlet jam
Description
Lines with rotary plate
The can-body guide must be active in the rotary plates. Can bodies will not be detected at the rotary plate run-out. The rotary plate will be stopped in case of jam.
The rotary plate can be started again with the "Rotary plate ON" button on the manual control unit. The line stop message can only be acknowledged with the"Rotary plate ON" button.
The sensor at the rotary plate run-out can also detect a can-body jam. To enable this function, parameter LineTurnerOutletCanJamIsMonitored must be set to TRUE.
Remedy
- Clear jam at the rotary plate run-out.
- Start the rotary plate again with the "Rotary plate ON" button on the manual control unit.
- Increase the LineTurnerOutletMonitioringDelay parameter.
- If monitoring is not used, input A056:In1 must be set to 24 volts.
- Check the digital input.