You’re offline. This is a read only version of the page.
After main switch off and on, HMI piece counter values and settings lost or old recipes loaded
Sheet damages at the front or rear Edge
PowerSTORE error message "Automatic Homing Failed"
What's an overvoltage suppressor? Is this a built in standard and how does it look like?
The linear axis does not move anymore. Motor drive error: F248 Low battery voltage
The wiring of the holding magnet could have a short circuit.
How to change the servo drive
The PowerCONTROL™ (touchpanel) only works in the docking station, but not if you remove it.
Canbody is only partially deflected by DCD or leading/following can body swings after DCD