You’re offline. This is a read only version of the page.
The can-body guide channel is not in position.
The belt tension on the oven conveyor is too low.
A measuring channel is not providing any information on quality or the information is not assigned to the corresponding, valid can-body number.
Insulation check of monitor taps
More than X (value can be selected in Options page) consecutive defective can bodies were detected.
A circuit breaker or motor protecting switch has tripped
The “Eject all can bodies” button was pressed on the remote control while production was in progress or an external command was issued.
An ejected can body passes through the confirmatory sensor too late or does not pass at all.
A can-body jam was triggered in the machine.
No quality information is available during production for can bodies arriving at the ejector.
The monitor channel did not detect the rear end of sheet.
The monitor did not detect the start of series of the first can body.
The leading end is not at the same position relative to the machine cycle signal as during calibration.
During calibration less than the number of can bodies selected in the Options page were welded.