You’re offline. This is a read only version of the page.
The temperature of the IGBT module is measured continuously. If this temperature exceeds the limit set under 'Max IGBT Temp', this error is displayed.
The measured housing temperature in the PULSAR is greater than the permissible maximum housing temperature under 'Max Case Temp' (standard = 60 °C).
The three fans in the side wall of the PULSAR are monitored for rotation.
The three fans in the side wall of the PULSAR are monitored for rotation.
The three fans in the side wall of the PULSAR are monitored for rotation.
An uncategorized or unknown error has occurred. This can occur since the drive system is continuously being developed and improved.
If an internal system monitoring of the ACOPOS responds, a fault in the system is indicated.
Hardware limit switches can be used to monitor limit positions of an axis or even to prevent running to the wrong direction.
The 24 V supply voltage of ACOPOS is below tolerance.
An expected sensor signal is missing.
Internal monitoring of the control software has been damaged. Stop the machine.
The wire loop is too short.
Crack in wire
Feeder protective door is open.
Protective door above the handwheel on the left side of the machine is open. The can-body guide channel is pushed through this protective door.