You’re offline. This is a read only version of the page.
An error regarding the position encoder of the motor has occurred.
Different reasons for ejection
Node could not communicate with the digital micrometer.
The mechanical wire width adjustment is no longer working.
The digital micrometer could not measure the wire width correctly.
The wire width measured varies too greatly.
Wire is too wide.
Wire is too narrow.
The CAN bus signals are outside of the specified range.
The CAN high signal is outside of the specified range.
The CAN low signal is outside of the specified range.
The CAN bus resistance is too high.
The CAN bus resistance is too low.
The CAN bus diagnosis module cannot be operated on this node.
The CAN bus diagnosis module does not respond.