You’re offline. This is a read only version of the page.
During the parallel switching of PULSAR devices every device must deliver the same amount of current.
The IGBT half-bridges are short-circuit-proof.
The IGBT half-bridges are short-circuit-proof.
If the output current of the PULSAR reaches too high a value, it is switched off because of overcurrent to protect the roller heads.
During the parallel switching of PULSAR devices every device must deliver the same amount of current.
The IGBT half-bridges are short-circuit-proof.
The IGBT half-bridges are short-circuit-proof.
If the output current of the PULSAR reaches too high a value, it is switched off because of overcurrent to protect the roller heads.
During the parallel switching of PULSAR devices every device must deliver the same amount of current.
If the retro interface is not selected and the function has been activated, the machine cycle or the can-body sensor is monitored.
Error 630.x Not in position
A problem in the integrated outputs (only ACOPOS, not ACOPOSmulti) has occurred.
A position error occurs if the controller detects an excessive deviation between the target position and the current motor position.
A software position limit cannot be maintained or was exceeded.
At least one phase of the power input is insufficient or is missing.