You’re offline. This is a read only version of the page.
Powder monitor This error is indicated when the mean value of the measurement during calibration is too high.
Powder monitor Average value without can body is too large.
Powder monitor Average value is too small.
Powder monitor Measured can-body lengths during setup are not stable.
A 24-volt circuit breaker was triggered.
The minimal cascade voltage could not be reached during start-up of production.
The minimal cascade current could not be reached during start-up of production.
Current for powder coating is too low. The measured power in the Soucoat hardware is less than 70% of the specified setpoint.
Powder monitor The reference data in the powder monitor is incorrect.
The suction is not switched on for the outside seam lacquering.
A 24-volt circuit breaker was triggered.
Shuttle 1 has exceeded the rear limit of travel.
Shuttle 1 has exceeded the front limit of travel.
Control cabinet temperature is higher than 50 degrees Celsius.
Compressed air supply is insufficient.