You’re offline. This is a read only version of the page.
Communication between drive has interference.
A digital output is overloaded or has no power supply.
Position difference is too large.
A fatal error has occurred in the servo amplifier.
Error during master resolver measuring.
Output current cannot be regulated.
Drive addressing is wrong.
No signal from reference (zero point) sensor.
Motor brake control detected interruption or short circuit.
The clutch did not engage.
The clutch of a chain conveyor is disengaged.
The clutch did not disengage.
The 24-volt feed power supply is monitored.
The profiling unit did not start when the wire drive started.
Feeder protective door is open.