You’re offline. This is a read only version of the page.
Welding machine: shielding gas on the inside and outside The flow of the shielding gas on the inside and outside is monitored.
No error in the burner control! The heating element has not ignited after the xth attempt (normally 3 attempts).
The burner element is in error status.
The safety combination of the oven (oven PNOZ) is not ready.
Seam coating system inside and outside An extractor hood is used for the inside seam coating system as well as for the outside seam coating system.
Feeder/rollformer: sheet flow monitoring The flow of the sheet from the feeder to the rollformer can be monitored.
Feeder/rollformer: sheet flow monitoring The flow of the sheet from the feeder to the rollformer can be monitored.
Feeder/rollformer: sheet flow monitoring The flow of the sheet from the feeder to the rollformer can be monitored.
Ejection diverter after STW accelerator belt: sheet flow monitoring.
A can-body jam has occurred in the EAC, DCS, can upender or the line interface.
Outside seam lacquering with spray system (OSS) The lacquer pressure can be monitored for the OSS spray system.
This message appears when parameter $MonitorMachineOffAfterContaminatedCan TRUE is set.
The can-body sensor positioned after the powder system does not detect any gap over more than three can-body lengths.
The maximum number of double sheets has been reached in the double-sheet container. The double-sheet container is full.
STW machine - tongue welding station The monitor has detected three badly welded tongues in a row at the tongue sealing station.