Error message: "Error down stacker"

Error message: "Error down stacker"

Cause:

• The setting of the magazine is wrong
   
• The separating air is not correctly set, or the air pressure is too low
   
• Too much tin plates – especially on can heights over 200 mm:
  • in the magazine, the weight is too high!
     
• Tin plates have too much burrs
   
• Suckers are worn
   
• Sucker height too low
   
• Linmot slider is not well positioned:
  • Pusher plate must stay around 2 mm behind the tin plates
     
• No signal of tool sensor B6:
  • Maybe gap between can body and sensor to big?
  • Maybe wire break and no signal on PLC/Pacemaker. Check cable and plug!