Where do I find my software version information on the Pacemaker
Remedy:
Using a han panel:
When you start up your Pacemaker, the software version will be displayed during the boot process.
Alternatively the information will we displayed, when you press the key “down” several times until you get to “Info Version”: e.g. 5.27
Using a CM16 welder you will also find the info by pressing the key “down”, since the display is the same as the hand panel of a Pacemaker.
On a X1 welder:
Tip on the *eye” icon and the Pacemaker software version is displayed on the bottom line.
On X8 welder:
Tip on the “eye” icon and then on a second “eye” icon to get to software version info on the bottom line – check also your manual book 1 – chapter 4.6. how to find the info.
