Error message: “Stripes twisted”
Possible causes:
Make sure that the lateral, adjustable top guides (see picture below) are set correctly in lateral position as well as in height. They shall guide and hold the stripes as flat as
possible over both sensors B260 and B261. Both sensors need to be reached at same time, otherwise the error will occur.
If the lateral guide is too far away from the sensor, the sheet might bulge. Therefore, move the lateral guide closer to the sensor.
NOTE:
Do not loosen the screw marked red. The standard setting for the top guide should be approx. X = 72 mm.
- Make sure that the pressing rolls are adjusted correctly (see picture above).
- Check the movements of the sheet, they might get stuck somewhere.
- Strip height is set wrong. Then the belt in front of the second operation is running too fast or too slow. This can create a problem with strip feeder LinMot.