The stripes are ejected through the frame of the second table
Problem:
First operation feeds the stripes too early into the upper magnetic belt of second table. Therefore, the stripes do not stop on the upper magnetic belt and will be ejected
through the slot in the frame of the second table.
Causes & Resolutions:
Sensor B255:
This sensor sends a signal to the control that the upper magnetic belt is ready for new stripes. The sensor may be defective or incorrectly adjusted.
Sensors B237 and B238:
Sensor B237 does slow down the sheets and B238 stops the sheets for the centering. If the sheets do not stop, they may run through the
first operation without being centered and with incorrect timing. The sensor may be defective or incorrectly adjusted.